HELP FILES

Forgotten Password Reset - Click here 

 

VIDEOS

►How to customize the text on just about any sticker.





Shipping Times
Shipping Times vary. All orders usually ship within 24 hours. Sometimes large orders with lots of customized changes take a little longer.
Large orders are shipped USPS Priority Mail with a tracking # and take 3-5 days to receive.
Small orders are shipped First Class Mail and can take up to 7 mail days to receive. If after 7 days you have not recieved your order please call us so we can help you.

--------------------------------------------------------------------------------

Can I use images and information found on this website for my own?
No, not without express written permission or a signed agreement from Stickerheads.com. All information and images created by Stickerheads.com
contained within this website and used on eBay, as well as information and images created by Stickerheads.com used in other venues are copyrighted materials. All copyrighted materials used without our written consent will be prosecuted to the full extent of the law.
 
► Installation & Removal Instructions

Sticker Application (Small graphics, any surface)
--------------------------------------------------------------------------------

1. Clean and dry the surface with paper towel.
2. Peel backing off sticker and make sure the sticker remains stuck to front application tape.
3. Place the sticker on the surface and squeegee the sticker with either a squeegee or a credit card. Professional squeegees are available in our store under supplies.
4. Squeegee from center to edges until the sticker has a good contact with surface. Don't start from edges or you'll get bubbles.
5. Slowly peel top tape off at an angle.
6. If bubbles are present, use a needle to carfully poke a small pinhole on side of bubble.
Do not use fingernail or squeegee to push bubble out! This may damage the sticker face. Instead use your finger to roll out any trapped air.
7. Smaller bubbles will dissapear with sun over a short time.


Sticker Application (Large graphics, any surface)

--------------------------------------------------------------------------------

1. Clean and dry the surface with paper towel.
2. Use masking tape to dry fit the sticker in place. This is how we get it straight and where you want it.
3. After the sticker is taped in place, put masking tape down the center of the sticker. Make sure to leave a few inches of tape above and below the sticker and onto the surface. Squeege the tape.
4. Slowly peel backing off sticker to middle where sticker is taped down center.
5. Tare or cut the backing paper away.
6. Squeegee the sticker from the center with either a squeegee or a credit card. Professional squeegees are available in our store under supplies.
7. Squeegee from center to outside edge until the sticker has a good contact with surface. Don't start from edges or you'll get bubbles.
8. Repeat for remaining side,
9. Slowly peel top tape off at an angle.
10. If bubbles are present, use a needle to carfully poke a small pinhole on side of bubble.
Do not use fingernail or squeegee to push bubble out! This may damage the sticker face. Instead use your finger to roll out any trapped air.
11. Smaller bubbles will dissapear with sun over a short time.


Sticker Removal
------------------------------------

1. Slowly pull vinyl sticker at a angle to remove sticker.
2. Older stickers may need a blow dryer or hot sun to help with removal.
3. A razor blade can be used on glass. Do not use a razor blade on a painted surface! And please use caution if you choose to use a razor blade.
4. Some glue may remain. This can be cleaned with alcohol, mineral spirts, paper towels and some elbow grease.
5. Keep cleaning until glue is soft enough to remove, then use window cleaner to clean and dry the surface.